Subject: Eazy intake EFI manifold.
From: Paul
Date: 8/18/1999, 9:09 PM
To: zz

X-Mozilla-Keys:                                                                                 
Marc Pedings wrote:

Paul wrote:

Hmmm. went to the shop and got a piece.  Boiled it, and sure enough, gets soft.
Thanks for stating the obvious

Marc Pedings

Excellent Marc. Thanks. I love it when people do some experimenting
on this far out stuff. On the other hand the manifold always

Heh, just don't ask what my wife thought I was doing. :-)  Seriously, I have been
boiling it for about 30 minutes now.  No sign of heat distortion, except that it is
soft.  I took it out (3/4" Sched 40 PVC) and bent it.  One VERY useful note, after it
cools, it retains its bent shape.  Just make sure you 'hold' it in its curvature
because when it cools, it tends to return to its original shape.  I made a curly Q,
but it collapsed in the middle., So.. ran a wooden rod back thru it (while hot) and
it stretched.  Reheated, bent it again and it retained its inner diameter.  After it
cooled, I was curious to see if the heating made it brittle, so I took it to the
anvil and busted it with a large hammer.  Another note: it is no more brittle than
another piece I cut off and broke to compare.  Given enough heat shielding, I believe
this will be good for making an unusual bend.   Hmm.......

Marc Pedings


The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org