Subject: Eazy intake EFI manifold.
From: Paul
Date: 8/18/1999, 9:18 PM
To: zz

X-Mozilla-Keys:                                                                                 
Bill Freeman wrote:

      *** SNIP  ****

Another idea. Does anybody know of a two part foam that would
be flexible after cure. I am thinking of casting it in the
greased up sched 40 PVC pipe, extracting it after cure and using
it as a male mold for an epoxy fiberglass manifold.

Paul Lamar

Paul,

No need to slip it out.  Just cut off the PVC with an abrasive
wheel in a dremel tool.   Wrap the form in duct tape with no
overlaps (cut thru the overlap with a razor blade then peel off
the under and overlap pieces for a perfect butt joint, like wall
papering).  

Great idea Bill! Start with the flex pipe, bend it
into the shape you want, fill it with
self rising foam, cut away the pipe and guess what!
I wonder what eats self rising urethane foam?

 Use an aluminum flange with 1" long stub pipes
welded on, cut roughening scores in the aluminum and then
gold alodine for extreme adhesion with epoxy.   Glass about
3 plies of BID cloth, cure and then dig out the foam and
peel out the duct tape, which won't stick to the epoxy.  This
will work and be very light with a smooth interior.

BTW, the aluminum int manifold castings on the Cont O-470 are
*very* light as is the thinwall SS321 exhaust system.  Amazingly
light, keep this in mind if you are trying to emulate the best
power to wt ratios out there for reliable high power fraction
motors.  **ALL** the pieces need to be light.  A pound here
a pound there, and pretty soon you are 150 lbs overweight.

Bill

I think those are mag because they are so light.
I have never seen sand cast aluminum that thin.
I wonder how they do that. Permanent mold?
Lost wax?

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org