Subject: Heat soak from turbo.
From: Paul
Date: 8/18/1999, 4:54 PM
To: zz

X-Mozilla-Keys:                                                                                 
May have mentioned this before, but we wrap all of
the exhaust on Nascar and similar applications with
Thermo-Tec heat wrap.
It serves two purposes, keeps the heat in the pipes,
and avoids radiated heat to the driver.
I have even used it on turbochargers.
Archie

Archie,

 Some guys on the RV list have mentioned problems (thinning/wear on head
pipes and some blowouts) even on high quality stainless exhaust systems
when wrapped long term with this stuff. Have you had any of these types of
problems or is this not an issue on race cars due to frequent
removal/replacement/inspection/etc...? Do you have any experience with the
applied thermal barrier coatings such as Jet Hot, etc.. and can you
recommend them?

Mike Wills


No problem in race cars using stainless. Only problem is moisture.
The Thermo-Tec will hold moisture, and initiates the oxidation process.
Not a problem if stored inside.
We have, and still use Jet-Hot in certain applications. Mostly hot street
and drag racers. It does not work near as well as the Thermo-Tec,
but is certainly aesthetically nicer, requires no maintenance,
and does prolong the tube life.

As in other things in life, there is no free lunch.
Always a trade-off, or compromise.
Archie


charles.harbert@fmglobal.com wrote:

Paul, I'd think twice before I'd heat wrap SS exhaust pipes, or a turbo on a
rotary due the the higher exhaust temps. The guys at Turbonetics recommended
against this when I was building my system because the big problem is burning
the tips of the wheel due to 1,700+ degF inlet temps. This kind of temp can only
be handled with inconel (max 1,750-1,800) (or ceramic) wheels. I know it's not
good thermodynamics to lose heat before the turbo, but in a rotary situation,
you're fighting too much heat.

At elevated temps, the internal wall of the pipe is probably being
eroded/oxidized by the exhaust gases, so you're better off the keeping the temps
lower. You can lower the temps with too little (lean), or excess, fuel, but
neither are desireable in an airplane. Sheilding and adequate airflow over the
exhaust seems to work fine.

I was wondering about this. Perhap wrapping  the tail pipe from the
turbo
is OK as most of the heat is gone by that time.

Paul Lamar

The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org