Subject: Eazy intake EFI manifold.
From: Paul
Date: 8/19/1999, 10:08 PM
To: zz

X-Mozilla-Keys:                                                                                 
Bill Freeman wrote:

Bob Darrah wrote:


Tracy Crook wrote:
Snip
 "No known solvent" for the cured foam.


Try a heat gun--I do not guarantee it will work on your foam but it
works on a lot of it.

Bob Darrah

I think that urethane is a thermoset and will just char
rather than soften like a thermoplastic.   It and silicone
are an absolute bitch to try to get rid of once cured.
There is a solvent that works half-way well on silicone,
but I know of nothing that disolves urethane.  I'll
ask some of our experts at work, sometimes we need
to depot a unit and I don't know if they dig it out by
hand or have some neat chemical that leaves the
electronics alone.

Bill


The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org