Subject: Eazy intake EFI manifold.
From: Paul
Date: 8/19/1999, 10:31 AM
To: zz

X-Mozilla-Keys:                                                                                 
Ugolini, Nick J wrote:

You could pack the tube with sand.  Cap both ends.  Heat the tube up until
it becomes flexible and bend into the shape you want.  With proper heating
(I would use heat lamps in the proper position) you could bend it into a
complex shape without collapse.    When shaped cut the ends off and drain
out the sand. Then saw the tube in half.  Clamp the tube back together with
hose clamps and use liquid pour foam for the form.

If you are going to make a series of tubes the same size and shape this
process might be worth the effort..

Nick


That also sounds like a very good idea. I need at least four tubes
for my intake manifold. Perhaps someone could make and sell foam
cores for this purpose. Anybody figure out what eats ureathane?

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org