You may get this twice.
I am having a little trouble with my ISP.
Jeff Spitzer wrote:
Vance Jaqua wrote:
Ken McCormick made his intake
manifold for his Subaru using that foam heat jacket
they sell for hot water pipes - the same stuff some
people use for padding hang glider bars etc - Epoxie
glas over and "pick" it out
Vance
Of all the ideas so far. I like this one the best. I am
going to get some of this stuff and wrap it with
strips of plastic and lay up a test sample.
Paul Lamar
This stuff really likes to spring back to it's original shape and doesn't
bend very tight. See if you can use heat to form it. If so then we'll
really have a winner.
Jeff Spitzer
I was just thinking about that. Perhaps one or two strands of
coat hangar wire would cause it to keep its shape.
The tightest radius I need is about three inches.
Here is another trick for inside the foam to hold it
in a particular shape.
This is a scale up of a device found in machine shops
to hold dial indicators.
The sperical beads and cylindrical spacers are about one
inch in diameter. The beads and spacers can be wood and possibly
be found in a children's toy shop. Worst comes to worse they
could be made on an NC lathe out of aluminum.
Once the shape of the curve is made
the nuts are tightened and the form will hold that shape.
You place the flex insulation foam over this form and wrap
it with plastic to serve as a parting agent.
Lay up the intake manifold. After it is cured the nuts are
loosened and the form is withdrawn from the foam mold.
The foam is then removed from inside the intake manifold.
Sounds more complicated than it is.
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org