Subject: Flex foam molds for intake manifolds.
From: Paul
Date: 8/20/1999, 11:53 AM
To: zz

X-Mozilla-Keys:                                                                                 
Mike Wills wrote:

At 07:40 PM 8/19/1999 -0700, you wrote:
Ken McCormick made his intake
manifold for his Subaru using that foam heat jacket
they sell for hot water pipes - the same stuff some
people use for padding hang glider bars etc - Epoxie
glas over and "pick" it out
Vance

Of all the ideas so far. I like this one the best. I am
going to get some of this stuff and wrap it with
strips of plastic and lay up a test sample.

Paul Lamar


 If you wrap the foam with plastic before doing the layup and the plastic
provides an airtight seal, try applying a vacuum after the layup is cured.
This should allow the foam to collapse and make it much easier to remove
from the tube than trying to "pick" it out. A guy who does auto upholstery
said they use this method to easily insert molded foam cushions int
pre-sewn envelopes. I havent tried it but seems like it should work.

Mike Wills


 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org