Subject: Flex foam molds for intake manifolds
From: Paul
Date: 8/21/1999, 12:45 PM
To: zz

X-Mozilla-Keys:                                                                                 
Bulent Aliev wrote:

Paul wrote:

Bulent Aliev wrote:

How about modeling clay? If you can make the form from clay, the lay up
can be made directly over it and then the clay can be dug up and
reused???
Bulent

Clay is good. In fact clay, cast plaster and cast wax is
is very traditional. When you really look into it... the
old ways are not that bad after all. One limatation
I have not been able to get around so far with cast
plaster is what do you do for a three dimensional
part with a parting line out of plane?

Paul Lamar

Paul, how about that: Gray PVC pipe, mark the cut lines on each side while
still straight. Bend by heating while full of sand etc. After the final
shape is achieved, cut each side individually and voila! Two part mold for
the male wax mold. The thickness of the cut should be compensated for
somehow which is no big deal. What do you think?
Bulent

We are getting there perhaps somebody could do this and
sell wax forms to the rest of us. 
 
Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org