Subject: Hi angle rod end for center stick. And composite manifolds.
From: Paul
Date: 8/23/1999, 11:53 PM
To: zz

X-Mozilla-Keys:                                                                                 
Vance Jaqua wrote:

Paul - where do you need the high angle for the center
stick? 

At the back end of the torsion tube. See the drawing I just
sent you. Also I just uploaded it to my web site. 


BTW one of our local 723 guys broke 30k with his normally
aspirated obsolete piston engines a turbo for 34k should be easy- Vance
Also I made a simple elbow out of low density urethane foam - smeared
with paste wax and glassed it - inside
surface was satisfactorily smooth, and poking out the foam was a piece
of cake - I would think carving the manifold would be good because you
could  optimize inner contour and have any radius or cross section that
you desired - Vance


 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org