X-Mozilla-Keys:
Ed Anderson wrote:
Ken Powell wrote:
And the answer is: use 1 alternator and 2 RG batteries, replacing
the
oldest battery during the Annual. Just like Tracy showed us in his
newsletter. AH, but now I am educated and understand WHY, so I can
sleep at night. Thanks to all of you for your input. (I still like
the idea of having a backup alternator but I am not sure it is
worth
the weight.)
A RAT is no big deal. Take any 12V brush type DC motor and put
a model airplane propellor on it>
You don't even need a second battery. . You just need enough juice
to operate the EFI and ignition until you can land.
Disconnect all other loads.
Probably only a couple of amps. Right Tracy?
Hi Ken,
I use 1 alternator and 2 RG batteries on my RV-6A. I have both
batteries wired directly to my "Hot" bus each thru a 40 amp pull type
circuit breaker. This hot bus is connected to the EFI and Ignition each
thru a high duty toggle switch. This way the only thing between my
essential systems (EFI and Ignition) and power is a circuit breaker and
switch. The reason for the 40 amp circuit breaker is to do remove either
battery from the circuit should it short. The batteries also connect to the
rest of the electrical system thru a relay (Contactor) similar to common
aircraft circuits.
I have a voltmeter that I can switch to either battery or the alternator, of
course to read the individual battery it must be taken out of the electrical
system by pulling its 40 amp circuit breaker. And as has been discussed,
normal voltage may not be a very good indication of battery health, however
abnormal voltage certainly indicates a problem of some type.
My High pressure fuel pump requires 5 amps (and it was the lowest current
one I could find) the fuel injectors (Mine are the surge and hold type)
require about 4 amps to open and then 1.8 amps to hold open for the
milliseconds of operation. Of course, the injectors are intermittent drains
and are off more than on so difficult to determine average drain, but I
would say no more than 1 amp. Then there are the ignition modules again a 5
amp or so drain but again intermittent, so perhaps another amp of average
drain. So that brings it up to 7 amps min. required.
This is just a WAG, but I would not feel comfortable with a system that
provided less than 10 amps for the essential systems. This may be a little
more than absolute minimum, but I for one like more than the absolute
minimum. I don't know what kind of current a RAT would provide or other aux
generating devices, so for my project, two batteries were the course
selected. I used two 25 AH batteries and now believe that is probably
overkill. A 12-17AH aux battery would probably be adequate for emergency
power to get you to airfield and two 17AH batteries on line for cranking
will certainly turn over a 13B with no problem. My 25 AH batteries weighted
22 lbs each whereas a 17 AM may only weigh 15 lbs.
I am coming up on my first annual and so must decide whether to remove the
main battery and move the aux battery to the main battery position and
replace the aux battery with a new battery or not. Both batteries appear to
still provide ample engine cranking power - but as we know, that is not the
best indication of health. The odyssey battery I have in the aux position
claims a 5 year operational life, so I believe that perhaps every two years
might be OK for replacement. On the other hand, yearly replacement is
certainly cheap insurance so long as the replacement brand has a low infant
mortality rate.
My 0.02 on the topic
Ed Anderson
RV-6A N494BW
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org