X-Mozilla-Keys:
Archie wrote:
I agree with the bearing placement/design discussed.
I am a technologies professor also. (Industrial Engineering)
Archie
This double stack of bearings should be angular contact bearings. If
you are going to take the thrust with them, they should both face the
same direction. If you are not, they should face opposite directions.
It does not say so in the Fafnir catalog but they do show
an angular line of contact. If I could find one bearing that
would do the job I would use it.
The size constraints are the stress on the machine screws holding
the ring gear bulkhead to the hollow output shaft. The output shaft
is probably larger dia. than optimum for the job. I would guess down
around 2 or 2 1/2 inch diameter might be closer to optimum
but that would over stress and reduce the number of machine screws
possible. This design is somewhat of an outgrouth of what
Everette Hatch successfully achieved. The output shaft connection
method is the same. One of the drawbacks to such a large shaft
other than weight is the size of the bearing required to support
it. That is one of the reasons I choose tapered roller bearings
because the ratio of OD to ID is very favorable.
I would like to avoid using two needle thrust bearings,
one on each end of the sun gear. I am open to other suggestions.
The Mazda engine rotates clockwise looking at it from the front.
That means the C6 sun gear would like to unscrew itself from
the planets toward the flywheel. That is why the old Ross PSRU
design has been destroying Mazda e-shaft thrust bearings.
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org