Subject: Eazy intake EFI manifold.
From: Paul
Date: 9/1/1999, 8:17 PM
To: zz

X-Mozilla-Keys:                                                                                 
Todd Carrico wrote:

<SNIP>
You can build any  form from blue, expanded styrene foam. It's very easy to
shape.  Than cover it in packing tape. Make the lay ups with glass and
epoxy resin (NOT Polyester. It will dissolve the foam) over the taped mold.
After cure wash out the foam with gasoline and you are done.
Bulent

I was trying to short cut the cutting and sanding process.

Paul Lamar

You may be able to hotwire a round core out of the blue foam
and then with gentle application of heat shape to your desired shape.

If it deformed you could fill/sand easy enough.

This would be the easiest to clean up IMHO.

That would work great for one or two manifolds.  For dozens
use the wax mold.

tc


 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org