X-Mozilla-Keys:                                                                                 
Pebvjs@aol.com wrote:

James;
set up the puller as before and tighten to apply tension. Then buy or borrow
an air impact hammer or rivet driver, install a blunt or mushroom head tip,
place a flat block of scrap iron up against the counter weight (so as not to
damage the counter weight by hammering directly on it ), apply a short hammer
burst to the scrap iron block and it will jump right off.
Ed.

The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org