Subject: Factory 13B pulley and accessory RPM speeds
From: Paul
Date: 9/7/1999, 5:12 PM
To: zz

X-Mozilla-Keys:                                                                                 
Brian D. Cain wrote:

Hey, I've been thinking here.  Just recently (Aug 25th weekend) I
spent the three days (well, Friday evening through Sunday night)
pulling the engine, cleaning it up/respraying the paint job, replacing
the clutch disc (switching to an ACT 6-puck bronze unit), and doing
the Hitachi HT18-S2 to 60-1 turbocharger swap.  Anyhow, because
of the size of the turbocharger, the port-arrangement of the engine,
and their respective change in power curve under wide open
throttle, I now currently tend to send the engine to around 7,500rpm
before I shift.  On the last turbocharger, however, I shifted early, thus
this wasn't a concern.

The concern I'm speaking about is the two accessories I still run
off of the crank -- the belt-driven alternator and water pump.  Of all
of the modifications done thus far, I haven't had a reason to buy into
the gimmick of an 'underdrive pulley' (however you wanna label it)
until now. I'm curious about, on the factory 13B crank pulley ratio,
whether or not the water pump truly cavitates at (x) RPM and
what kind of range we're talking about for the alternator before it's
considered 'overspinning'.

Thanks.

B

-] Brian D. Cain, FC Motorsports. 
-] 1988 Mazda Rx7 Turbo II/FC3S -- 13.86 - 104.08mph.
-] Dallas, TX   (214) 885-8227 ICQ#: 1733105
-] http://rotary.simplenet.com/fcm/intro.html


The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org