X-Mozilla-Keys:
JMLBlues@aol.com wrote:
A diesel fueled rotary engine is not a true diesel. Any single-stage rotary
(as opposed to the two stage device Rolls Royce played with in the '60s) that
runs on diesel is really a spark ignited stratified charge engine. As such,
the ignition and combustion process is not truly compression ignition (diesel
cycle). One of the reasons that a stratified charge rotary engine (SCRE) can
be made light weight relative to a diesel is that the combustion pressures
remain relatively low. In my experience, SCRE combustion pressures typically
are below 1500 psi with good combustion. In fact, the design target was
always 1200 psi. Diesels can run over 3000 psi. The fuel delivery system and
combustion chamber shape are designed to handle the fuel in a manner to
minimize self-ignition from high pressure and therefore to obtain controlled
burning via a smooth flame front.
Intercooling the SCRE is an important tool for keeping the combustion
pressures down. Intercooling was really a requirement to get the desired
power density.
I'd like to clarify my earlier comments on the Wankel engines. My experience
was limited to diesel fueled Wankel engines. I never ran (or saw run) a
Wankel gasoline engine. The engines I was involved with were originally
designed as relatively low output naturally aspirated engines. We applied
turbocharging and intercooling and obtained much, much higher outputs than
the engine was designed for. It was no surprise to anyone that some design
changes were in order to deal with the increased stresses. In
naturally-aspirated form, the engines ran quite well. Although NA was not our
focus, I would expect the engines to have been reliable and durable at the
designed rating.
Jonathan Lauter Rotary Power Marine
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org