Subject: Yet another motor mount design mock up.
From: Paul
Date: 9/9/1999, 3:17 PM
To: zz

This is definetly not FAA approved for inverted flight.
Here is the first cut on the motor mount mock up. The next step
is raise the engine and move it back a bit. Then I will
slip the cowl over and see if everything clears.

The tubes shown are 3/4 conduit mashed flat with a hole
drilled in the end. Everything else is low cost hardware stuff. 

There might be a conflict with the channel brace tube and the
intake manifold. In that case the brace tube can go to the lower
rear intake manifold bolt. I will draw a detail of that.

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org

kismm1.jpg