Subject: Yet another motor mount design mock up.
From: Paul
Date: 9/10/1999, 8:25 PM
To: zz

X-Mozilla-Keys:                                                                                 
Bill Freeman wrote:

This is the left side of course. Just below the rear housing
intake port is a intake manifold bolt that can be used
to brace the aluminum channel.

Note: I have a six port front housing and a four port rear
housing. I have no idea what the center housing is.

This mock up engine is like one of everything :-)

Paul Lamar

Paul,

The big disadvantage to aluminum for  something as critical as a
motor mount is that it fails instantly in even a very minor fire.
The ensuing displacement may make the AC unflyable either due
to the total loss of the engine moving the CG unrecoverably
aft, or due to extremely high drag plus possible severely
assymtric aero forces due to a partially displaced cowling
(like 45 nose down, 30 deg right).

I would stick to steel for the motor mount.  But then again,
its YOUR airplane and you can do whatever you want.  :-)

Bill

Good point Bill. A 3 X 1 channel could be bent up out of
.049 or .063 4130. I think I will do that. Better safe than 
sorry. In that case the brace tubes can be just welded
to the channel with a few gussets. Thanks for that thought.

Course the same thing could be said about 
Lycoming  dynafocal type rubber mounts.

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org