X-Mozilla-Keys:
Paul wrote:
Bill Freeman wrote:
This is the left side of course. Just below the rear housing
intake port is a intake manifold bolt that can be used
to brace the aluminum channel.
Note: I have a six port front housing and a four port rear
housing. I have no idea what the center housing is.
This mock up engine is like one of everything :-)
Paul Lamar
Paul,
The big disadvantage to aluminum for something as critical as a
motor mount is that it fails instantly in even a very minor fire.
The ensuing displacement may make the AC unflyable either due
to the total loss of the engine moving the CG unrecoverably
aft, or due to extremely high drag plus possible severely
assymtric aero forces due to a partially displaced cowling
(like 45 nose down, 30 deg right).
I would stick to steel for the motor mount. But then again,
its YOUR airplane and you can do whatever you want. :-)
Bill
Good point Bill. A 3 X 1 channel could be bent up out of
.049 or .063 4130. I think I will do that. Better safe than
sorry. In that case the brace tubes can be just welded
to the channel with a few gussets. Thanks for that thought.
Course the same thing could be said about
Lycoming dynafocal type rubber mounts.
Paul Lamar
I recieved a nasty gram on this subject implying that
I am incompetent to design motor mounts because aluminum
motor mounts might melt in a fire. That is true
but Bonanza's and Cessna 210's also have aluminum motor
mounts and they are thin sheet metal and not 1/8 thick
channel. Probably almost all bed mount Continental
engines probably use aluminum sheet metal mounts.
I have never read or heard of an inflight fire
causing a problem with these airplanes in this regard.
Not your fault or problem Bill.
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org