Subject: 10G motor mount & landing gear.
From: Paul
Date: 9/12/1999, 10:03 PM
To: zz

X-Mozilla-Keys:                                                                                 
Bill Freeman wrote:
Just a bit of support for the 10G motor mount spec, which
IMHO should also apply to the gear.  Both see their most
severe load condition during a hard landing.
snip...

 > Paul Lamar wrote:
I wonder what people are going to call me when I ask
them to pick up a 3000 pound car with thier motor
mount using the fuselage as a lever???? :-)

Vance has some recent expierence along these lines.
What do you think about all this Vance?

Paul Lamar


Vance Jaqua wrote:

Most homebuilt or kit aircraft landing gear are history after about 2.5
"G", and generally don't have any problems with that except for an
occasional bowed aluminum main gear. Good design is usually about 3.5
to 4 "G" but you need about 6 inches of travel to hold that level in a
FAR 23 landing. Nose gear seem to be a bigger problem - probably
because your wing is not helping there like it did for the mains - I
think a 10"g" motor mount is a bit overkill but if it does not get too
heavy - go for it - Vance

The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org