Subject: Rotary Power Marine bell housing.
From: Paul
Date: 9/13/1999, 11:11 AM
To: zz

X-Mozilla-Keys:                                                                                 
Paul wrote:



At Rotary Power Marine Corporation, we have our own bell housing that mates
to the engine on one end and has what is known as a "Borg Warner" pattern on
the other. The housing is cast of 319 aluminum and has a mount for a starter
motor near the top of the engine. If anyone thinks this housing may be of
use, let me know. I will try to post some kind of a drawing, but it will take
me a while.

Jon Lauter
Rotary Power Marine Corporation
516-656-5685

Sounds great Jon. Should solve a lot of PSRU problems.

What does it weigh?
And what does it cost?

Is this a picture of it?

rpmbell.jpg

Paul Lamar

Bulent Aliev wrote:

That's exactly what I wanted to do with the Mazda bell housing. I like Jon's much
better. Too bad the starter is not mounted lower. The cowlings usually slope down
at this point.
Bulent


 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org