Subject: Improving sand cast aluminum strength.
From: Paul
Date: 9/23/1999, 8:49 PM
To: zz

X-Mozilla-Keys:                                                                                 
Bill Freeman wrote:

JDana2@aol.com wrote:

Paul.    there is some new rechnology out to take a sand casting of aluminium
and turn it into one that has the strength of a forging . I believe Mac-DOUG
developed it. I my be wrong as to who developed it , but nevertheless, its
compressive strength would be much greater as part of the process is to
subject the casting to heat and tremendous pressure. In doing so the
grainstructure changes and the porosity dissappears. A gentleman who owns a
casting house told me about this process.  It might help in the making of the
aluminium housings for the Mazda. JIM DANA

That should be of great interest to Mazda but nobody I know is
considering making Mazda rotor housings as inserting the steel
liner in the casting  is daunting.

Paul Lamar

Sounds like HIPing (Hot Istostatic Pressing) and it does work.  Basically
heals up all the voids and flaws in the casting, making it nearly as good as
a forging.  I say nearly because you still don't get the preferential grain
orientation that can be obtained with a forging, which can be of significant
benefit if planned for and used wisely.  Not cheap and would
not be useable for the complex Mazda casting with internal water passages, since
(the ones that I have seen) require wrapping in stainless or inconel foil,
which is not possible down in the passages.  If you wrapped the whole
thing, the water passages would be "healed" - not a desirable outcome. :-)

Bill


The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org