Subject: End Housing wear and Lapping
From: Paul
Date: 9/27/1999, 8:03 PM
To: zz

X-Mozilla-Keys:                                                                                 
James Phillips wrote:

Ok guys I'm looking for some advice so I've sent this out to a bunch
of people. I've been trying to decide what to do with my end housings.
The stepped wear on 3 surfaces is .002-.0025. On the front end housing
it is a solid .005. The mazda book says .0039 is the limit. So should
I have the three good ones lapped or can I still expect good
compression if I leave them as is. As for the bad one, how can I tell
if it is possible to lap it. I called Mazdatrix today and they say
they can't know if its possible to Lap them until they see them. The
problem is that it will be expensive to send them from Michigan just
to see if it is doable.

     So I'm looking for someone who has had some experience in this
area. I understand that the concern is the depth of the O-ring groove
after lapping. Does anybody have any idea how shallow this groove can
be and still seal? It just seems to me that this shouldn't be quite so
subjective. I have to believe that there must be some rule of thumb
for O-ring grooves and how deep they must be to seal. Seems to me it
would be simple to measure the current groove depth and subtract the
.005 that must be removed to make the end-housing flat again and use
that number to make a decision. 

I'm sure that I must be missing
something. Anybody got any input? Also does anybody know of another
place to get these things lapped. Mazdatrix did say that they could be
surface ground. I may have better luck finding someplace local that
can do that. I did find some lapping shops listed in the Detroit
yellow pages and I will explore that avenue. But without some data on
how much can be removed I still not won't know if it should be done or
not. Thanks in advance for any light you can shed.   James Phillips

P.S. Sorry Tracy and Bruce as you probably got this message 2 or 3
times since I know that you are on the lists also. I just wanted to
make sure I got the question to you guys.


The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org