X-Mozilla-Keys:
Jeff Spitzer wrote:
At 07:09 PM 9/25/99 -0700, you wrote:
Jim Mosur wrote:
Hi Paul
I have been monitoring my coolant return from rads to engine. Coolant to
rads 187 F., coolant from rads. to engine 135-140 F. Hard climb temps are
5-8 degrees higher.
Jim Mosur
RV6 13B
Outstanding Jim! Thanks for the data.
It is a
amazing that it is so close to theory as outlined so well by
Rodger Hilyard. I hope my single rad design does as well.
I think we are slowly getting a handle on this.
HOLY CRAP!!!! If these numbers are right then the mystical rotary cooling
problems are suddenly all clear to me. That's waaaayy too little water
flow. Can someone please verify the 13 GPM number? A 200 hp engine should
have at least 3x that much water flow for obvious reasons. The radiator
can't work without a good temp difference. All this talk about thick,
thin, etc has been a waste of time compared to this significant problem.
Not too long ago, Paul Yaw asked me about improving the pump and I told him
to put more air in the radiator instead. If the 13 GPM number is right
then I was wrong. The pump needs work. If someone will confirm the
miserable performance of the pump I'll go to work on a fix right away.
BTW, this doesn't bode well for the engine in the front, cooler in the back
schemes. With lousy water pressure one cannot afford those long runs.
Jeff Spitzer
Maybe I can talk Mazdatrix out of a spare pump and mount it in my lathe.
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org