Subject: End Housing wear and Lapping
From: Paul
Date: 9/28/1999, 10:23 AM
To: zz

X-Mozilla-Keys:                                                                                 
Jeff Spitzer wrote:


James Phillips wrote:

 Seems to me it
would be simple to measure the current groove depth and subtract the
.005 that must be removed to make the end-housing flat again and use
that number to make a decision.


Possibly the concern from Mazdatrix is the overall removal required to make
them flat again.  You are only measuring one place.  In order to know the
full requirement you must set up the housing on three adjustable inspection
jacks.  You float an indicator across the entire surface and keep adjusting
the jacks until the surface reads as true as possible.  If the surface is
perfectly flat everywhere else then you will only have to remove .005.  If
it also has .005 of warpage then maybe you really have to lap .010 before
it cleans up.  BTW, you need a good surface plate and a height gage to do
this right.

Jeff Spitzer
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org