X-Mozilla-Keys:
Tracy Crook wrote:
Herb Sanders wrote:
Paul, As I remember Tracy's RV4 installation, he had small hoses (about
like auto heater hose) approx 1" OD. If his installation is successful
with thick cores and small hose, is the theory of thin cores, large hose
(-16), and super output water pumps really using the right
base requirements? I'm learning and enjoying the engineering exchanges,
but it seems the answers are far apart from what we know works - I'm not
being critical, just trying to get comfortable with the requirements.
Herb Sanders
Paul wrote:
Good point Herb. I was kind of waiting for Tracy to comment on this.
He has had some cooling problems however. I would also say thick
verses thin has as much do with cooling drag as it does
with cooling per se.
Paul Lamar
I use two 5/8 " ID hoses in parallel (one to each A/C evaporator core
radiator) from the waterpump. This is probably near the minimum size
required. While I was at Copperstate fly-in, a guy walked up, looked at my
cooling hoses and laughed. He said the engine would never cool with such
small hoses. I said I was glad that I flew 2200 miles from Florida so he
could tell me that. The temperature that day was 100 degrees. Five
minutes later two other guys walked up and one said to the other, "Those
rotaries would be OK if somebody could ever figure out how to cool them."
And of course these comments were nothing compared to ones about the
"horrible torsional vibration" of rotaries.
Yes, I do spend a lot of time at 40 - 50% power (just because I enjoy the
ride at that speed) but I have done full power runs at sea level for almost
an hour (plenty of time for temperatures to stabalize) with the engine
sucking down 17 GPH. Even assuming a lousy SFC of .55 this is at least 185
HP. (these numbers are for the "new" engine)
On the waterpump discussion, I think the stock pump is pretty well matched
to the job. I did notice that my cooling was slightly better before I
changed to the smaller pulley on the E-shaft (which slowed the pump down).
Slowing the alternator down was the reason for the change. I noticed no
signs of pump cavitation with the stock pulley at my max RPM of 6250. The
car racers tell me that anything under 7000 RPM is OK on the stock part.
Paul commented that I waffled a bit in my last newsletter on what the best
radiator configuration is. The truth is, I'm still not sure. Thick & thin
both have their advantages and the art of aircraft design is always picking
the best compromise.
Tracy Crook
Speaking of Copper State Tracy are you going to be there this year?
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org