Subject: Method of insuring proper hot water distribution.
From: Paul
Date: 10/3/1999, 10:25 AM
To: zz

This is kind of trivial but if you don't ask for
it when you order your rad you probably won't get
it. The core I intend to use is a late model
Mustang core about 27 inches by about 19 or 20
mounted under the engine.

The header will be about 1.7 inches wide but the tubes
are only one inch. If it proves inadequate I have room
for doubling the thickness and running the hot water
in the back side and taking the cool water out the
front. This should result in roughly a 20% improvement 
in core efficiency over a simple two row core.. 

See the drawing on the ACRE NL web site for this rational.

The water pressure drop will double over
the simple two row which is the down side of this arrangement.
Jeff is coming up with a better pump anyway.. hopefully. :-)

The air pressure drop should double which of course 
is also the down side of a thicker core. There is 
nothing I can do about that as there is only so much dynamic
pressure to work with. You can open up the duct intake 
opening untill you are blue in the face but only so 
much air will go through the rad. The rest will go around
the outside of the opening in an external diffusion manner.
The bottom line is it will have more drag.

So hopefully I can get by with a one inch core.

I also intend to use big cowl flaps to suck a lot of
air through during climb and close them down at cruise.

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org

radheadr.gif