Bill Freeman wrote:
SNIP
BTW Jim Mederer (Racing Beat) and I discussed the rotor housing
shrinkage problem when the engine is overheated. He brought up
a point that I don't think we have discussed so far on this
subject. Jim says; "Why bother with necked down tension bolts or
bellville springs under the tension bolt heads? If the engine
over heats the rotor housings are trash anyway because the
heat treatment goes away. Simple solution. DON'T LET YOUR
ENGINE OVERHEAT!" Easy for him to say :-)
Paul Lamar
Paul,
IIRC, aluminum heat treatment takes place at about 900-1000F,
so you would *really* have to overheat the engine to wreck the
heat treat on the aluminum. I think this is a red herring, and the
efforts to prevent the crushing of the housings is valid.
Bill
Wow! he had me convinced. I thought aluminum started to get
soft around 500. It could get to 1000 degrees right
adjacent to the combustion chamber.
While I have you on the line Bill
here is a picture of my O-470 with the powder coated
baffles and the fiberglass reinforced silicon rubber
sheeting you recommended. Looks and works great. I still
need to trim the sheeting a bit.
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org