X-Mozilla-Keys:
Paul wrote:
SNIP
BTW Jim Mederer (Racing Beat) and I discussed the rotor housing
shrinkage problem when the engine is overheated. He brought up
a point that I don't think we have discussed so far on this
subject. Jim says; "Why bother with necked down tension bolts or
bellville springs under the tension bolt heads? If the engine
over heats the rotor housings are trash anyway because the
heat treatment goes away. Simple solution. DON'T LET YOUR
ENGINE OVERHEAT!" Easy for him to say :-)
Paul Lamar
Paul,
Bill Freeman wrote:
IIRC, aluminum heat treatment takes place at about 900-1000F,
so you would *really* have to overheat the engine to wreck the
heat treat on the aluminum. I think this is a red herring, and the
efforts to prevent the crushing of the housings is valid.
Bill
Wow! he had me convinced. I thought aluminum started to get
soft around 500.
Jeff Spitzer wrote:
Paul's right. If you look in Mil-HDBK-5 you'll find that the heat
treatable aluminums get soft (and stay soft) really quick at about 500 deg.
There isn't any data for 356 but in my experience it's worse. One good
hot spell and bye-bye temper.
Jeff Spitzer
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org