Subject: Reliability / Life of Rotary vs Piston (SEAL Velocity)
From: Paul
Date: 10/7/1999, 10:23 AM
To: zz

Keith Moore wrote:

Morning Paul:

Automotive designers empirically determined that a piston engines life >is improved by  limiting the piston speed to less than 2500 ft/sec.   >The standard is now an over-square short-stroke engine design capable >of a relatively high RPM and HP.


I've always been curious as to what the Rotary's average apex seal >speed is, since the rotor is geared to one-third the shaft RPM.

The chart shows it to be 16% higher than a comparable piston engine.
This is from K.Yamamoto's book "Rotary Engine".
Seal speed alone is not the main criteria for wear.
A piston engine wears the most at TDC when the piston
stops and starts up in the other direction and seal 
speed is zero.

In the rotary the seal is always moving which helps
maintain the oil film but it does change
angle relative to the rotor housing. An important 
factor is the radial inertial forces of the seal.
All this is too much to go into here but you
might be able to find the book.

PL


1.   At what RPM is the apex seal velocity 2500 ft/sec?
2.  What is the seal velocity at our 6000 RPM operating design point?

I anticipate that the rotary may have a low apex seal tip velocity at >design RPM, another "arrow in the quiver" in favor of the rotary's long >life.


Regards,

Keith "Blackhat" Moore


The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org

apexspee.jpg