Subject: More questions about rotary engines.
From: Paul
Date: 10/11/1999, 11:13 AM
To: zz

X-Mozilla-Keys:                                                                                 
Fred wrote:

Paul:

I queried a friend who raced rotary engines years ago and is currently flying
a Lycoming in his Lancair.  His comments follow.  The comments about EGT were
news to me.  Are they still valid?  I ask because high temperatures are death
on metal lifetimes, and I wonder if turbos could be a problem.

"The engine has three problems, square corners to seal, low compression ratios
and gasoline fuel. Actually the three are related as you are aware. There has
been a lot of work on stratified charge (spark assisted diesel) engines that
would have multi fuel capability. You can't get the compression ratio high
enough
and the seals good enough for true diesel operation BUT there is the Hyperbar
system. Basically this is a high pressure ratio dual supercharger that allows
diesel operation at 9:1 CR. Also, direct injected engines would avoid the
other
problem, high EGTs. The combustion chamber geometry requires late ignition
timing (25 degrees vs 40 degrees) so gasoline engines require inconel exhaust
components. Turbocharging gasoline engines is problematic due to these high
EGTs."

He also noted the high power that is possible form a small light weight
package:

"The Wankel is an excellent candidate for an AC engine. Call it a positive
displacement turbine ;) The 4 rotor LeMans engine weighed 180 kg, produced
515 KW (690 Hp)@ 9000 RPM, 609 NM (450 FtLb) @ 6000 RPM  (513 Hp) NATURALLY
ASPIRATED. Not bad for 2.6 liters. This engine is based on the 13B automotive
engine and will run a very long time at 6000 RPM as the rotors only spin at
1/3 the crank speed. A gear reduction is required but the torque ripple is
very small."

Thanks in advance for your comments.

Fred

Looks very accurate to me except for the comments on sealing.
Sealing has long since ceased to be a problem. Especially for an 
engine that runs at 5000 RPM all of the time. The engine will
actually run with out seals if you can somehow get it started.
Most people looking for ultimate durabilty on high HP engines 
(over 200 HP per rotor) take a couple of steps back from the 
stock three piece apex seals now used by Mazda
and use one piece apex seals to improve durabilty.

About the compression ratio. I don't know if you would call
10:1 low given todays low octane fuel. That is still with a bath
tub shaped depression in the rotor flank.

Vance of course will say that a four rotor is really
7.8 liters and not 2.6 liters :-)

Paul Yaw and Tracy Crook have been doing some work on ignition timing
so I am not sure if 25 degrees advance is the real limit on timing.

The high EGT is a problem but as I recall it cools off when you lean
it out. Tracy has done some work on that at high altitude.

BTW Tracy has 850 hours on an 0.035 thick stainless steel exhaust
manifold with no problems.

A turbo aircraft engine would probably require an inconel exhaust
manifold and inconel turbine which is not much extra money these days.
Chuck Harbert is flying a turbo three rotor with those.
Those are also what I plan to use on my engine.

The stock Mazda 13B 280 HP RX7 turbo engines use cast iron manifolds.

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org