X-Mozilla-Keys:
Brian D. Cain wrote:
Hey guys. I've recently gotten interested in doing some more
down-to-earth math in terms of calculating injector flow rates
at given duty cycles at given pressure ranges/changes and
am running into a brick wall when I'm trying to convert any of
my flow rate numbers into measuring the amount of air that
this can "support" at a given ratio.
I am using this formula for calculating single injector flow rates:
Injector Flow (cc/min) = Rated Flow (cc/min) * (SqRt [New Pressure/Rated
Pressure])
I believe this to be accurate when considering a 'rated' pressure
of 36psi on average (I believe most of those published 'hey our
new gee-whiz injector shoots 2,000,000cc/min' numbers to be
rated at this pressure) along with an 85% (or maximum) duty cycle.
My problem is this: First off, I'm missing any reference to BSFC
concerning the rotary engine in these calculations. Secondly,
when I figure the amount of fuel, barring the fuel pump(s) running
out of steam and/or related rail pressure (indicative of a volume loss)
problem, I come up with a flow rate of 4.549lbs/min out of 2x550cc/min
injectors alongside 2x720cc/min injectors operating under a rail
pressure of 46psi. This comes out to somewhere over 72gph.
I believe at this point my math is missing something because, if I cram
this number into a direct, 12:1 ratio of air/fuel, attempting to solve for
the amount of air that can move at the same time unit of lbs/min, it
calculates to well over 54lbs/min. This seems a bit outrageous and I'm
scratching my head on it. I'm trying to honestly figure out what needs
to be addressed in my current fuel system. I already know the pump I
use isn't up to par and I'm starting to believe that having 720's in-place
of 550's in the secondary 3rd and 4th injector ports is a bad idea.
Anybody have any input on this?
B
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org