X-Mozilla-Keys:
Fred wrote:
Drag is the momentum drag (cooling drag) that results from the cooling air
flow alone assuming that the outlet area is adjusted via cowl flap to the
optimal value to accelerate the existing hot air as much as possible using
any surplus pressure left over after paying the losses in the inlet diffuser
and across the radiator. No drag effects from external belly scoops, etc. are
included since they require separate analysis.
Radiator width is held constant at 24 inches. (Width and height are
interchangeable - it's the frontal area that counts).
The analysis assumes that the enough air is forced through the radiator to
carry away the heat which must be rejected. Thus if the radiator is too
small (as in too thin, not enough surface area) more air must be forced
through it to get rid of the heat. Higher drag results.
Thanks, Fred, for very interesting curves, but I'd like to understand better
how to apply to a different airplane. Is the drag shown on the charts due
to pressure drop across the radiator only? How much is this relative to the
inlet diffuser losses? Does this analysis assume constant inlet area and
then slow the air in proportion to the radiator area? Trying to get a feel
for air velocity through the radiator.
Altitude is 15,000 feet, and power is 165 HP, 75% of the 220 hp that Marv
gave me to work with (turbo engine). As I recall, the BSFC assumed is 0.5
lbs/hp hour. Lower altitudes can get by with smaller
radiators due to higher air density.
I've been under the impression that since we generally fly our airplanes
according to "indicated" air speed, the change in density with altitude is
already accounted for; that is, we fly at a constant ram air pressure, so
we're getting the same amount of cooling flow regardless of altitude. What
am I missing?
Al Gietzen
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org