Fredmoreno@aol.com wrote:
Good choice of figures Paul. I use an modification of this figure as the
core of my lecture on cooling and cooling drag.
Fred
I just acquired and old air conditioning squirel cage blower and I was
thinking of bulding up a test rig to do some pressure measurements
on an oblique cooling block configuration. I need to verify to my
satisfaction that the pressure will more or less be evenly
distributed. I was thinking of building just a plywood wedge
shaped box with a Ford rad core sealed at one end and blowing
into it.
Do you have any test setup configuration suggestions Fred?
The gif is a page from Kuchemann & Weber's Aerodynamics of Propulsion
just so we know what I am referring to here. obliqueb.gif
Paul Lamar.
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org