Subject: Better yet Super compact heat exchanger
From: Paul
Date: 10/20/1999, 11:01 PM
To: zz

X-Mozilla-Keys:                                                                                 
Fredmoreno@aol.com wrote:

Reviewing and thinking about it a bit more, I have another concern.  The fin
length cannot be too long or the conduction losses down the fin become
excessive.  For a 0.006 Al fin, the maximum distance from tube to end of fin
(or middle of fin between tubes) is about 0.2-0.3 inches.  Also, we want the
fins to be interrupted every 1/8 inch or thereabouts to provide lots of sharp
leading edges and short boundary layer build up distance.  How about putting
the tubes into the W configuration to make a folded heat exchanger with a
"thick" core (thickness being the height of the W)?  Making the header tanks
might be a problem.  Need to think of the manufacturing restrictions.  But
you are thinking out of the box, and that is important.  What's good for
autos is not necessarily what's good for airplanes.  Different requirements.

Fred

This core is not suitable for use in a car. The only use I can see at
the
present time is for an airplane either under the cowl or in a belly
scoop.

I could fund a small test article. Know anybody that would be interested
in building one of these for test purposes? Care to add your first guess
on
best dimensions for tube angle, fin spacing and fin configuration?
A sketch would clear that up for me.

Based on what I discovered with a 20 inch long wedge I was thinking of 
keeping the height of the W to 10 inches for better air pressure 
distribution hence air flow. If the W is too high I suspect the
flow through the core will be non-uniform with most of the flow
occuring  near the bottom of the W. In other words we might run 
into the same problem I had with the 20 inch wedge. Even ten inches
may be too much. Perhaps further optimization is possible by 
changing the tube angle or spacing from top to bottom of the W.

I have given some thought to the header tanks and they could be 
corrugated and brazed together to take the coolant pressure. Much like
the freezer box in a fridge. One big top header and one big bottom
header.

The big advantage here is the air does not have to turn 90 degrees
and a conventional axial-symmetric diffuser could be used. I hope to 
get less air pressure drop than conventional tube cores folded into a V
or
W shape with a practical amount of projected frontal area.

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org