X-Mozilla-Keys:
Russell Kent wrote:
Yes I agree. You also want turbulent air contact with both sides
of the tube. If one side is laminar and the other is stalled
it might be less efficient in terms of heat transfer.
Which is (again) why with a symmetric airfoil like the radiator uses (the tube)
you want a 0 AoA.
We need to study this on a micro level. The fins could
also be saw tooth shaped. To optimise this thing might require
a lot of experiments.
I just thought of another use and that is in the air conditioning industry. I
think they would
appreciate a low air pressure loss compact heat exchanger with
this form factor (shape). It would be a waste of time and money for
car engine cooling but might be useful in the car air conditioning
system.
I'm not completely following you. Please expound.
Russell Kent
The form factor is defined by the overall height width and thickness
of the heat exchanger. A large area thin low drag radiator works
fine in a car.
An airplane can use such a low drag radiator if it is mounted at an
acute angle to the general airflow. In that case the air must turn
almost 90 degrees to go through the core. This will work and is
working very well in Jim Mosur's and other people's airplanes
but we need to do some more work on the duct to even the flow
through the rads.
If a thick (more than about 3.5 inches) conventional core is used
such as a P51 type the air flow restriction and drag is great.
Now we have room for a moderate height and width, say 24 inches wide by
about eight inches high. In a belly scoop or under the cowl we may also
have room for a ten inch thick radiator. That is where the better yet
super compact heat exchanger comes in. The air is only seeing a one
inch thick zig zag core while the over all thickness is ten inches.
If this is still not clear let me know and I will make another sketch.
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org