X-Mozilla-Keys:
Fred wrote:
Keep in mind that most of the heat transfer in a good radiator design comes
from the fins between the tubes, not the tubes themselves. Fin area should
be about 3-5 times tube area, and fins should be staggered about every 1/8
inch to prevent boundary layers from becoming thick and increasing thermal
resistance. Good fin design present lots of sharp leading edges to the flow
by offsetting the fins as you move from front to back of the radiator.
However, these superior designs are difficult to make and thus expensive,
normally restricted to the aerospace industry where performance and weight
rule the day. The Griffin radiator with lots of tiny louvers punched into
the serpentine fin configuration provides good heat transfer (much better
than plain serpentine fins which are BAD), but at a cost of more pressure
drop, about twice what you get with the best staggered, offset fin
configurations. You pays your money and you takes your choice.
Fred
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org