Subject: lapping/nitriding side housings/Q for Bruce T.
From: Paul
Date: 10/21/1999, 6:05 PM
To: zz

X-Mozilla-Keys:                                                                                 

The housings that were lapped at LAPCO are for a 12A bridge ported engine
that will go in a rally car our company is partially sponsoring.  The car
belongs to guy named Andrew Havas. The results looked very good. The finish
should be smooth but dull. They looked exactly the same as those I had lapped
by Racing Beat, except for the blue tone from the nitriding process.  R.B.
recommends polishing the housings with 600 grit lubricated with WD 40. I
prefer a rubber block instead of a power sander. The polishing only takes a
few minutes and looks shiny but less than mirror.

LAPCO called me today and expressed that they were happy to work with us
rotor heads but on the 86 and later housings, you need to make the decision
as to the limit of material taken off. Mazda says .003", I have heard of
several people taking off up to .007" per face without any O-ring problems.
Rust pitting will toughest defect to get out since it can be relatively deep.
When time permits, I'm planning to take several sets of housings (a truck
load) down to them to have reworked. Probably next week.

As far as nitriding is concerned, it seems to be a safe process. We measured
a slight warp at the bottom of one of the lower legs on the front housing but
I don't think it was caused by the nitriding process since the other side of
the leg was perfectly flat.
Bruce Turrentine

BruceT2598@aol.com
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org