Subject: Peripheral port pipe size and butterflys. Timing.
From: Paul
Date: 10/22/1999, 12:06 PM
To: zz

X-Mozilla-Keys:                                                                                 
There is another factor here too. The diameter of
the pipe
changes its tuning. Going from 2 inch tubing to 1
5/8 dia
will lower the tuned RPM about 500 RPM keeping the
runner
a constant length. The volumetric efficiency will
not
change. If you increase the length without changing
the
dia the tuned RPM will be lowered AND the volumetric

efficiency will increase at the same time. All this
according
to Heisler's Advanced Engine Technology.

So the hot tip is use a large and long pipe. Mazda
did so on
the normally aspirated four rotor Lemans winning PP
engine and got
about 120 HP per rotor or 240 HP at 6000 RPM from a
13B. Not only
that the BSFC was at its lowest point throughout the
range.
In other words an improvement of 30 HP is possible
over
the Power Sport engine. Probably with lower fuel
burn.

As I recall the pipe was about 24 inches long and
two inches in diameter.

See the lemanhp.jpg HP chart below.

Paul Lamar

Vance Jaqua wrote:

Changing the resonant length with diameter seems a bit
strange - I wonder if it may be similar to a Doppler
effect because of the velocity of the flow - in normal
acoustic study increases in diameter reduce the "Q"
which can be related to resonant efficiency and will
tend to reduce the peak and "broad band the response
-interesting ?????? Vance


 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org