X-Mozilla-Keys:
BTW Al I am sure you have figured this out but I thought
I would mention it anyway. The Ai over Ab is the inlet area
over the cooling block area in K&M speak or the rad frontal
area. The first column would then be the one of most interest
in the coordinate chart.
All this works for vertical rads so it is not too
relevant to the angled rads in our type ducts. That is why
I am having a rad wind tunnel made.
I had another idea today. The water manometer works fine but
it is kind of expensive to gather that type info using a computer
as you need very low pressure sensors and A to D amps and so
fourth.
So I came up with the idea of using those cheap little cooling fans
on Pentium processors as air flow sensors to gather
data under real world conditions while one is flying around.
One can get plug in cards for a PC that has counters on it.
You then need an LED and photo transistor to detect the blade RPM
which should (after calibration with the Omega air speed meter) be
proportional to air exit velocity from the back side of the rad.
Four such units evenly spaced around the rad surface should be
good enough for government work. Perhaps one more in the middle
for reference.
See the ACRE NL web site for a skematic of the LED/photo transistor
sensing circuit. http://home.earthlink.net/~rotaryeng/
If the fans prove to be a simple brush type DC motors... in generator
mode one could feed the output voltages to A to D converters.
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org