X-Mozilla-Keys:
I checked with Barry and they claim Neoprene is good to
93 C or 200 F.
BTW I decided to move my 4130 hat section closer to the firewall under
what would be the back rotor housing in a car installation.
This gave me a wee bit more room to move the rad up closer
to the ring gear at a slightly less acute angle.
In most cowls this will allow a slightly wider rad as well.
Some of my thoughts on angled rad ducts.
>From what we have determined so far it looks like it is going
to take a fiberglass 3D distorted bell shaped duct to get
even airflow through angled radiators. 2D wedge shape
ducts work of course but the bell shaped 3D duct should work
even better. More when I get the rad wind tunnel working.
A male duct mold could be carved from foam covered with packing
tape. The fiberglass should have
some ribs or other stiffening techniques as it will be
subjected up to about 100 pound per square foot pressure
at 200 MPH and above. It must be bolted to the sides of the
rads as under this much pressure it will try to separate.
Fred, question. With a large cowl flap this should suck air
through a small intake opening and eliminate most external
diffusion. When the flap is closed we get more external diffusion.
Does this sound right?
One other thing. IMHO The 25% rule of
thumb for the intake opening area is probably based on a rad
3 or 4 inches thick. Perhaps we can go down to 15% to 20%
for intake area with thinner, larger area rads.
Does this sound plausible Fred?
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org