Subject: Building a new 93 or later 13B
From: Paul
Date: 10/26/1999, 3:46 PM
To: zz

X-Mozilla-Keys:                                                                                 
Here is the story I have Bruce. The 87-88 bath tub depression in the
 rotor face was as cast so they lowered the compression to
 accommodate production variations. The 89-91 were machined so
 quality control was much better and they are all 9 to one
 instead of some being 9 to one and others being 8.6 to one.
 I guess we could cc them much like people do with cylinder
 heads.

This is the same understanding that I have. The later machined rotors are
easy to spot based on the texture of the dish. (no rough cast surface) The
later rotors are also lighter and must be used with the 89-91 or 93-95
counterweights. 87-88 rotors weigh approx 4300g and the 89-95 rotors weigh
4075g.


 BTW make me up a list of new and used parts to save the $1100
 bucks and I will send you a check. If you don't have a list
 I will try to work up one and send it to you for editing.

 I would like to use the machined rotors if possible but
 I can always CC the older rotors. That means of course
 one would wind up with a compression ratio of the lowest
 rotor face out of two rotors. I would prefer of course
 to have the late 9 to one with machined bath tubs.

I have several sets of the 89 and up turbo rotors, (turbo II's and twin
turbos ) so that's not a problem. The 89-91 rotors and the 93-95 rotors do
have different part numbers but their weight, shape and compression ratio are
the same. No one at Mazda can tell me why they have a different part number,
but I do know that they are interchangeable.
Bruce Turrentine      BruceT2598@aol.com 


 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org