Subject: Hayes special o rings
From: Paul
Date: 10/27/1999, 5:02 PM
To: zz

X-Mozilla-Keys:                                                                                 

        I am pretty sure I will rebuild with these o rings, but heard 1 story in
which excessively lapped housings caused cracking of these particular o
rings.  (it was 1 of 3 apparent bad rebuilds from Hayes experienced by the
same guy (!?)) I'm assuming .003 is not too much to lap (I'm assuming a max
of .003 will clean up my housings.  Is everyone using these?  Is it worth
the bother?  The $115 cost is not really an issue, but if they do no good I
won't bother.  Any additional thoughts?

BTW thanks Bruce for the call!

Tom
Tom Jelly, HSBC Futures at the CME  312-559-1057 7am-2pm.   773-348-6549
(H)  773-206-6764 (cell)

Ed Anderson is using them with no problems so far.
I can't imagine how one could crack a silicone rubber O ring
with a Teflon coating. I certainly don't believe a 
groove only .003 less in depth would have much effect
at all. Much depends on who you heard this story
from.
 
Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org