X-Mozilla-Keys:
I don't have Ed's email address, but I do have a question for him. Can you
please forward my question to him? The question is "Why did you choose to
use a - 4 hose end fitting to terminate your - 3 size hose instead of a - 3
size hose end fitting? Aren't there - 3 hose end fittings available that
could screw onto a - 3 AN conversion fitting that converts to a 1/4 inch male
pipe thread or just about any other reasonable size or thread that could then
be threaded into the female brake assembly opening?" Many thanks.
One other note of interest is that if you order preswaged Speed Flex hoses
from Earl's you will wind up with either brass or steel hose end fittings.
If you want aluminum fittings on the ends of your Speed Flex hoses you will
have to install them yourself as Ed describes above.
'OC' Baker, Builder of KIS TR-1 #116 4/14/97 - ?/?/?
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org