Subject: Integral firesleeve hoses & brake lines.
From: Paul
Date: 10/29/1999, 5:59 AM
To: zz

X-Mozilla-Keys:                                                                                 
Ed Anderson wrote:

I use the Teflon lined stainless steel braided hose for brake lines in my
RV-6A size -3.  I use fittings which have a -3 hose end and a -4 fitting
end.  The -3 hose end fitting is slipped over the hose, then a special tool
with a pilot is inserted into the hose teflon while the outter edge of the
tool peels back the stainless steel braid from the teflon liner.  A brass
"o" ring (coupling? forget the name for it but similar to those used in
flared gas lines) is inserted.  The teflon tube sticks throught the brass
"O" ring and the stainless steel braid on the out side of the brass "O"
ring.  When the -3 hose end is slid back up to screw on to the -4 hose end
fitting, it compresses the braid onto the brass "O" ring and the "O" ring on
to the teflon liner which is compressed aginst an inner hollow tube from
the -4 end.  Difficult to explain, but the secret is the niffty little tool
which separates the stainless steel braid from the tefelon liner.  Also
there are two types of "O" rings, brass for steel fittings, and Aluminum for
aluminum fittigs.

FWIW


 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org