Subject: Integral firesleeve hoses & brake lines.
From: Paul
Date: 10/29/1999, 7:05 PM
To: zz

X-Mozilla-Keys:                                                                                 
I don't have Ed's email address, but I do have a question for him.  Can
you 
please forward my question to him?  The question is "Why did you choose
to 
use a - 4 hose end fitting to terminate your - 3 size hose instead of a
- 3 
size hose end fitting? Aren't there - 3 hose end fittings available that 
could screw onto a - 3 AN conversion fitting that converts to a 1/4 inch
male 
pipe thread or just about any other reasonable size or thread that could
then 
be threaded into the female brake assembly opening?"  Many thanks.

One other note of interest is that if you order preswaged Speed Flex
hoses 
from Earl's you will wind up with either brass or steel hose end
fittings.  
If you want aluminum fittings on the ends of your Speed Flex hoses you
will 
have to install them yourself as Ed describes above.

'OC' Baker,  Builder of KIS TR-1 #116 4/14/97 - ?/?/? 

Ed Anderson wrote:

Hi OC,

      Its been a while ago, but as best I recall the fittings on the RV-6
brakes are AN-4 while the  nearest  teflon hose line size from Earls (at
least at that time) was -3.  Apparently this was not uncommon as Earl's had
the -3 hose to -4 fittings readily available in Steel.  So I ordered the
steel ones with brass inserts and fabrcated the lines myself.  Its possible
I could have found -3 fittings with -4 NPT to replace the fittings on the
brakes and then used -3 hose and fittings, but just didn't seem worth the
effort.  So to answer your question they were available and fit the need of
the moment.

Ed Anderson
eanderson@carolina.rr.com
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org