Subject: Is the rotary designed for direct drive?
From: Paul
Date: 11/2/1999, 9:44 PM
To: zz

Perry Mick wrote:



Perry, I don't know if I've seen a picture of how you have directly coupled the
prop to the eccentric shaft/flywheel, but I sure hope you have a separate
bearing system to handle both end and side thrust loadings, and that you're not
relying on the engine's internal thrust and eshaft bearings. These engines
bearings are absolutely not designed for those kind of loads. You must isolate
the prop loads into a bearing system that translates these loads to the engine
block, then to the motor mount and then to the airframe.
Chuck Harbert

Perry wrote:
I'm breaking those rules.

I'm basically using a prop extension bolted to the flywheel through an
adapter.

Maybe aircraft engines are designed to handle long prop extensions, but
maybe the Mazda can't.

The attached photo is pretty clear.
Perry Mick
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org