Subject: 20B - BTU for oil and water coolers
From: Paul
Date: 11/3/1999, 6:40 AM
To: zz

X-Mozilla-Keys:                                                                                 

VO wrote:

Paul,
I looking for information on 20B oil and water
cooler for Velocity in BTU /hour or /minutes.
I believe somebody flying one already, and
could give me an idea what I need to have
and where I could order.


Al Gietzen wrote:
I've done the analysis and come up with these numbers that you may find
useful:

Assuming 260 hp max power output to the shaft, the total heat from the fuel
burn is about 38,500 Btu/min.
About 18% of this goes into the coolant - 6,950 Btu/min.
About 7-8% goes into the oil  -  2,900 Btu/min

The Mazda high output pump will provide less than optimum flow rate from a
radiator design standpoint (~20 F coolant temp drop); but should allow to
design to about 26 - 30 F drop. Pick your design point, but as an example;
for 60 F temp rise in the air, you need an air flow of about 5800 cfm
(ft^3/min) for sustained full power operation.

I don't know the oil flow from a high output pump, but you'd like about 20
gpm at full power.  Air flow requirement for oil cooler is about 2500 - 2700
cfm.

Hope this helps.
Al Gietzen


BTW  King 1 800 855 1001 has hand held digital anemometers for $89. $20
less than
Omega. .7 MPH to 89 MPH. 3% accuracy 400 hour on watch battery. No web
site. PL

 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org