X-Mozilla-Keys:
charles.harbert wrote:
Paul, I though about using a combination water/oil cooler, but decided not to
because of the following reasons:
1. You are always going to get a much higher delta T from the air stream than
from the water. Thus you'll need a much greater surface area to obtain the same
cooling. I think you would end up with a larger overall cooling system using
this approach, plus trying to balance the 2 cooling requirements might be
problematic.
2. The oil pressure is much greater than water pressure and if you get a leak it
will go into the water system which is better than the other way around (other
than if you circulate water thru tubes in the oil pan). However, oil in you
water is not good either, so I felt it was better to keep them totally separate.
3. Most race cars have separtate systems, and Mazda kept them separate.
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org