X-Mozilla-Keys:
Perry Mick wrote:
I've started disassembling a 13B in my garage, and when I took the
front cover and components off, I was shocked when I saw the size
of the thrust bearing. I have no knowledge of how to analyze it's
capability, but it sure doesn't look like much.
I have 44 hours on the hobbs meter, and I would guess at least 35
of those hours have been spent taxi-testing or flying. Actually the
flying part is about 5 hours. So there are a lot of hours of thrust
producing activity already on the engine.
Maybe now is a good time to take the engine off and see what it
looks like inside. Bad weather is setting in anyway. Thanks for
the input, Charles.
Bill's ideas are good if I want to stay with what I've got, but it
seems like it would be easier to call up Mr. Ross. My plane would
go faster in the end anyway.
Perry J. Mick
Mick Duckt N7XR
http://www.mickaircraft.com/duckt.htm
Tracy Crook wrote:
Actually, the problem is not with the load rating on the Mazda thrust
bearing. SKF rates it at 9300 pounds. The problem is the speed rating
which is 2800 RPM. If you analyze the movement in the bearing, you will see
that there is a lot of miss-matched surface velocity between the inner and
outer ends of the needles. This skidding action generates heat and it is
crutial that sufficient oil flow be present to carry it away, especially
since we are asking it to go twice as many RPM.
I went with a thrust type ball bearing in my re-drive which had a lower
thrust rating but a higher speed rating.
Tracy Crook
rws@altavista.net
www.rotaryaviation.com
I second that on needle thrust bearings. They have limited RPM
capabilties. In a car it is running way less than 3000 RPM average
and there is little load on it 98% of the time.
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org