X-Mozilla-Keys:
charles.harbert wrote:
Jeff, I was comparing the thrust loadings from a helical gear vs. the entire
thrust being applied to the engine thrust bearing for the same engine/plane
combination. I wasn't comparing my plane to Perry's.
I think Tracy's later memo explains what is actually happening. I suspect that
Mazda and other auto engine mfgs design the thrust bearings in the engine for
intermittent modest thrust loads from clutch application usually at lower rpm. I
know that's probably how I would do it.
p.s. to Paul: I haven't run the numbers, but I would think that the thrust (420
vs 300) necessary to push my 4 place plane 250 mph, would be a lot more than 40%
to push Perry's 2 place plane 120 mph. What am I missing (helical gear vector)?
charles.harbert wrote:
The thrust loading for a direct coupling is many, many times this small
PSRU load.
Jeff Spitzer wrote:
Are you sure about this? Paul cited a pretty high number for the helical
thrust load which I believed at the time. The thrust from that dinky prop
is probably less than 500 lb.
Jeff Spitzer
350 gross HP is 280 net HP out of the prop at 250 MPH or 366 FPS
is 420 pounds of thrust. About the same as I recall as the
helical gear thrust.
In Perry case he has about 120 gross HP or 96 net HP at 120 MPH
176 FPS or about 300 pounds of thrust. Assuming of course his
prop is 80% efficient which is doubtful.
Paul Lamar
Chuck,
I made some assumptions about your HP, prop eff. and your top speed.
Once you do that the rest is arithmatic. HP is thrust times velocity
so if you know the HP and you know the speed you know the thrust.
You also know the drag BTW.
One HP is 550 pounds of thrust moving at one foot per second.
The helical gear thrust formula is T = F * TAN(helix angle)
F is the tangential force and T is the thrust in pounds.
The Ford C6 sun gear has pitch diameter of roughly 1.8 inches.
>From that you can figure the tangential force given the torque.
The helix angle from eyeball is about either 30 degrees or 60
degrees depending. Probably 30 degrees.
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org